Cut to size fret wire sets
In this category you will find:
- Fret wire sets pre-cut to a certain size
Please measure the width on the 1st and last fret
Also check the kerf size with the feeler gauge (tang + 1 / 10mm = kerf size)
- If the frets are seated with a fretting hammer, we recommend over-bending the radius. Put the fret wire piece on the fingerboard. If there is about 0.5-1mm of air in the middle, that fits. If not – bend by hand using slight thumb pressure between your fingers.
- Don’t think too precise! The difference e.g. between R = 9.5 "and R = 12" is only 0.17mm at the 1st fret and 0.4mm at the end. This is easily bend by hand.
