Very nice crafted traditional fret file for the ambitious luthier;

• Files cutting edge has on both sides hollow groves for recrowning medium size (>2-2,7mm) frets after levelling.
• It's shallow radius allows you also recrowning of flat frets.

Custom made for leveling frets. Very even and straight file block, smooth cross cut on both sides. Size app: 200x40x8mm
Cut is more coarse than 04030006.

Use this special tool to file accurately and fast the 35° angle to newly installed fret wire ends. 

Precisely flat file block for leveling frets. Has hard wood handle which has a flat top. Can be used with fine grit sand paper for additional honing after filing - a good time saver before recrowning. Very smooth file cut - low cutting force due to it's propper weight. Professional Quality.

Very handy fret hammer with two different hammering surfaces
Threated heads for easy replacement

Fret-end file
Cut on narrow sides until the edge
Use it after the three corner file to cut the burr to the fret board
One side flat, the oposite rounded

• Cross section: 3 x 1,6mm
• Total length: 155mm

This is the professional coarse (#150)fret file for recrowning as a first step when much material has to be removed in fast strokes.
Use the fine diamond fret file 04040001 as next step to remove possible file marks.
The file has two different radius on the edges.
Cutting length: 100mm
Total length: 200mm

Custom-made Fret Cutter to cut as flush as possible close to the edge of the fingerboard to safe filing time.
With a long edge life, even with extra hard fret wire.

• Also suitable for stainless steel fret wire
• Total length: 200mm

Precision straight edge for checking and adjusting the fingerboard Flatness (relief) on basses with many scale lengths (30/32/33/34/35/36").
Basses with baritone, short, medium, long and extra length scale can be edited with this straight edge.

MADE IN GERMANY

Neck support made from hardwood with protective felt. Use e.g. while fretwork.
Material: hardwood
Dimensions: approx.25cm x 7.0cm x 3cm

Fret leveling file, extra fine, 150x25mm with ergonomic hardwood handStück
Intended for dressing and leveling frets and also fret ends. Works quickly without chatter.

• Size (L x W x H): 150 x 25 x 55mm
• Cut: single cut

Very nice crafted traditional fret file for the ambitious luthier;
This file is for recrowning frets after levelling and has one cutting edge for small (app. 2mm) and one for very small frets (1-2mm).
 

Spring loaded holder for sanding belts - the ideal helper for sanding on single fret crowns

• Sanding belt: 324 x 6,35mm

For cutting out the fret feet (tang) at fret ends (e.g. binding on fingerboard)
Robust all-steel design with resharpenable and replaceable tool