Pocket size ruler to measure out string action and setup standards
Etched version for professional use
Scale with 1 / 4mm  gradation ranging from 0.25 to 3.5
0-20mm ruler on both sides
0-75mm ruler
Back: Conversion table millimeters to inches with fractions
Material: stainless steel, 0.3mm
Size: app. 90 x 50mm

Fret-end file
Cut on narrow sides until the edge
Use it after the three corner file to cut the burr to the fret board
One side flat, the oposite rounded

• Cross section: 3 x 1,6mm
• Total length: 155mm

This is the professional coarse (#150)fret file for recrowning as a first step when much material has to be removed in fast strokes.
Use the fine diamond fret file 04040001 as next step to remove possible file marks.
The file has two different radius on the edges.
Cutting length: 100mm
Total length: 200mm

Very robust Fret Bender in the 3-roller principle for individual bending and adjustment of fret wire to the required fingerboard radius.

• Also suitable for stainless steel
• For fret wire from 1,5x0,6mm to 4,3x2,5mm