Custom made for cutting off fret ends flush very close to the fretboard - saves you a lot of filing time!
Robust design and extra hardened jaws (30mm) gives long life - also very hard fretwire.

Custom-made Fret Cutter to cut as flush as possible close to the edge of the fingerboard to safe filing time.
With a long edge life, even with extra hard fret wire.

• Also suitable for stainless steel fret wire
• Total length: 200mm

For cutting out the fret feet (tang) at fret ends (e.g. binding on fingerboard)
Robust all-steel design with resharpenable and replaceable tool

Fret-end file
Cut on narrow sides until the edge
Use it after the three corner file to cut the burr to the fret board
One side flat, the oposite rounded

• Cross section: 3 x 1,6mm
• Total length: 155mm

Fretwire for guitar, bass and other fretted instruments

• Nickel-Silver 18%
• Extra hard
• Straight
• Width (w): 2,0mm
• Crown (h): 1,3mm