Fret wire replacement with the Chip Stopper Set, 0.3mm + 0,5mm. For guitar, bass, also mandolin and ukulele etc.

1x 0,3mm + 1x 0,5mm

Use this special tool to file accurately and fast the 35° angle to newly installed fret wire ends. 

Fret leveling file, extra fine, 150x25mm with ergonomic hardwood handStück
Intended for dressing and leveling frets and also fret ends. Works quickly without chatter.

• Size (L x W x H): 150 x 25 x 55mm
• Cut: single cut

Custom-made Fret Cutter to cut as flush as possible close to the edge of the fingerboard to safe filing time.
With a long edge life, even with extra hard fret wire.

• Also suitable for stainless steel fret wire
• Total length: 200mm

Fret-end file
Cut on narrow sides until the edge
Use it after the three corner file to cut the burr to the fret board
One side flat, the oposite rounded

• Cross section: 3 x 1,6mm
• Total length: 155mm

Fret Rocker: 6-sided straight edge for checking unevenness in fret heights before and after levelling.

• This miniature precision ruler is made of 2mm thick stainless steel
• precision ground on all edges.
• Antiglare sufrace
• Size app.: 100x55mm
• Edge length app.: 12 / 20 / 30 / 50 / 70 / 95mm

Made in GERMANY

This is the professional coarse (#150)fret file for recrowning as a first step when much material has to be removed in fast strokes.
Use the fine diamond fret file 04040001 as next step to remove possible file marks.
The file has two different radius on the edges.
Cutting length: 100mm
Total length: 200mm

Precision straight edge for checking and adjusting the fingerboard Flatness (relief) on basses with many scale lengths (30/32/33/34/35/36").
Basses with baritone, short, medium, long and extra length scale can be edited with this straight edge.

MADE IN GERMANY

Precisely flat file block for leveling frets. Has hard wood handle which has a flat top.
Can be used with fine grit sand paper for additional honing after filing - a good time saver before recrowning.
Fast material removal and  smooth file cut - low cutting force due to it's propper weight.
Professional Quality.

Neck support made from hardwood with protective felt. Use e.g. while fretwork.
Material: hardwood
Dimensions: approx.25cm x 7.0cm x 3cm

• Precision feeler gauge with 20 sheets of 0.05 to 1.00 mm.
• Ideal tool to measure the width of the fret slots
• Nickel plated bracket with locking screw
• Blade length 100 mm.

Spring loaded holder for sanding belts - the ideal helper for sanding on single fret crowns

• Sanding belt: 324 x 6,35mm

Set of six fret board guards for almost every fret wire
Improved version with practical possibility of fixing by a rubber band!

Very robust Fret Bender in the 3-roller principle for individual bending and adjustment of fret wire to the required fingerboard radius.

• Also suitable for stainless steel
• For fret wire from 1,5x0,6mm to 4,3x2,5mm